Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 188)

188 K2 Media Client User Manual June 5, 2009
Chapter 10 SDA-00: Audio/Video Configuration
MPEG:D10 compression format setup
To access record channel video settings, open Configuration Manager, click Channel ,
and select a record channel (R1, R2).
For this setting... Configure as needed…
Compression
format MPEG:D10 Selecting this format makes settings available
as documented in this table. MPEG:D10 is a
licensable option.
For other format settings, refer to
“DV
compression format setup” on page 186 and
“MPEG compression format setup” on
page 186
.
Recording data
rate 30 Mb/s
40 Mb/s
50 Mb/s
Input type SDI —
Analog Composite When the reference standard is NTSC and this
setting is selected, it makes the following
setting(s) available below:
Input pedestal
Input pedestal On If you are operating with a standard NTSC input
signal with 7.5 IRE setup, then make this
selection. You must make this selection for both
record channels.
Off —
Automatic VITC
detection On Makes the following setting(s) available below:
Starting VITC line
Ending VITC line
Off Makes the following setting(s) available below:
VITC line 1
VITC line 2
Starting VITC line
-or-
VITC line 1
NTSC: Between 10 and 20
PAL: Between 6 and 22
Ending VITC line
-or-
VITC line 2
NTSC: Between 10 and 20.
PAL: Between 6 and 22
VITC present Green LED indicates VITC is present.
Black LED indicates VITC is not present.