Table top mounting, Cut out dimensions for surface mounting, Mounting holes for panel fastening – Grass Valley KayakDD-2 v.6.7.1 User Manual
Page 43
KayakDD-2 Digital Production Switcher
6.3.2
Table Top Mounting
In many cases the panel can just be put on a table. Gummed feet prevent accidental
movement of the panel.
6.3.3
Cut Out Dimensions for Surface Mounting
For surface mounting of the control panel the cutout dimensions are:
791 mm x 400 mm
CAUTION!
Regardless of mounting method or cutout dimensions, ensure that there is at least
2 inch (50 mm) of clear space at the rear of the panel below the mounting surface for
proper cable clearance and air flow.
6.3.4 Mounting
Holes
for Panel Fastening
For fastening the panel in a table there are four M4 thread drillings on the panel. Those
allow to fasten the panel from below the table. The length of the screws is dependent
on the respective thickness of the tabletop (see Figure 9 and 10 with mounting details
below).
The figure below shows the position of the mounting holes.
42
Planning and Installation Manual