Grass Valley Performer-HD - Manual (Page 33)

Performer-HD Instruction Manual 3-1
Section
3
Operation and Maintenance
Introduction
The Performer-HD will select any one of the ten input sources for output
on its single destination. Protects can be set so that the current selection is
locked and prevented from accidental change.
It is possible to control a Performer-HD from a 110 Production Switcher, or
from an RS232 or RS422-compatible terminal or computer. Control from a
Production Switcher is invisible to the Production Switcher operator (pro-
viding the Production Switcher is appropriately equipped and configured).
Use of RS232 or RS422 control via a terminal or computer is dependent
upon configuration and connection requirements. The Serial Protocol De-
scriptions provide the technical information needed for control from pro-
duction switchers and terminals.
Performer-HD Front & Remote Panel Operation
When using a Performer-HD with any remote controller, the Performer-
HD is the master panel; it can remove protects placed by the remote con-
troller. Except for this difference, the following operating descriptions ap-
ply to both the local integrated control panel and the remote control panel.
The Performer-HD panel display does not tally Source, destination, and
level offsets. When several panels used on a bus are used to control several
Performers, other means (such as labeling) must be used to identify the
Performer associated with each panel.
Figure 3-1. Performer-HD Front
A1
CH 1/2
A2
CH 3/4 Video
Grass Valley 1 2 3 4 5 6 7 8 9 10
Input Selection
Performer-HD
VAA
Breakaway/Protect Status/Display
V A1 CH1/2
On HD Vid
Present Reclock
Off
A2 CH2/3
A2
CH 3/4