Grass Valley Profile Serial Digital - Manual (Page 28)

Serial Digital I/O Upgrade Installation
20 Serial Digital I/O Upgrade Installation
Figure 4. Screw locations for board mounting bracket
4. Install the blank circuit board brackets (if necessary) in the empty board slots
on the rear panel.
5. Connect the audio clock and Sharcnet cables (see “Audio Clock and
Sharcnet Cabling” on page 22).
6. Use the Torx tool with the T10 tip to reinstall the rear board hold-down
bracket (see Figure 2).
7. If necessary, reconfigure the front board hold-down bracket, moving or
removing a short board extension, and use the Torx tool with the T10 tip to
reinstall the front board hold-down bracket (see Figure 2).
8. Use the Torx tool with the T10 tip to reinstall the rear top cover with the
screws previously removed.
9. Use the Torx tool with the T10 and T15 tips to reinstall the front top cover
with the screws previously removed.
9040-13
1
2