Grass Valley PDR 100 Master Enhanced Disk Recorder Board - Manual (Page 33)

Replacing the PDR100 Covers
PDR 100 Master Enhanced Disk Recorder 23
Replacing the PDR100 Covers
To replace the PDR100 covers:
1. Set board area cover in place (
Ê in Figure 19) and use the Torx tool with the
T10 bit to replace the twelve cover screws; eight on top and four from the
side.
2. Set disk drive cover in place (
Ë
in Figure 19) and use the Torx tool with the
T10 tip to replace the cover with the screws previously removed.
NOTE: Your PDR 100 may have more disk drive cover screws than shown in
Figure 19 if you have 9GB drives installed.
Figure 19. Replacing PDR100 covers
1
2
9674-12