Grass Valley Profile CD-ROM Drive - Manual (Page 32)

PDR100 Installation
32 CD-ROM Instructions
Installing the Parallel Port
This procedure describes how to install the parallel port on PDR 100 systems with
the 486 System CPU board. The parallel port will provide a 25-pin D-connector
for attaching the CD-ROM drive to the PDR100.
This procedure has three parts:
- Removing the Top Covers
- Verifying Switch Settings On the VGA-I/O Board (if installed)
- Installing the Parallel Port L-bracket
- Enabling the System CPU Board Parallel Port
Removing the Top Covers
To remove both chassis covers:
1. Confirm that the PDR100 power is switched off and the power cord is
removed.
2. Use the Torx tool with the T10 tip to remove the top screws from the front
chassis cover (➊ in Figure 6).
NOTE: Take care not to lose these chassis screws. They are required to meet
the EMI specifications for the PDR100.
3. Use the Torx tool with the T10 tip to remove the rear chassis cover
(➋ in Figure 6) which covers the circuit boards.