Grass Valley Profile Family Audio Signal Processing Board - Manual (Page 22)

ASPB Installation
22 ASPB Installation
Removing the Circuit Board Hold-down Brackets
There are two hold-down brackets located in the circuit board area of the chassis
that must be removed in order to install other boards.
To remove the board hold-down brackets:
1. Use the Torx tool with the T10 tip to remove the exterior screw
( Êin Figure 2) that secures the rear board hold-down bracket.
2. Lift the bracket (
Ëin Figure 2) up and out of the chassis and set it aside.
3. Use the Torx tool with the T10 tip to remove the interior screw
( Ìin Figure 2) that secures the front board hold-down bracket.
4. Lift the bracket ( Íin Figure 2) up and out of the chassis and set it aside.