Grass Valley PFR600/E - Manual (Page 50)

Chapter 3 Servicing the PFR600 Series RAID
50 PFR 600/E Instruction Manual 20 February 2004
Replacing a power supply
CAUTION: Turn off the power supply before unplugging the power cord from the
supply or removing the supply from the chassis.
To replace the power supply:
1. Turn the standby switch to Standby (0), as shown.
2. Remove the electrical cable from the power supply.
3. Loosen the captive screw on the power supply.
4. Pull the module out of the enclosure, as shown.
5. Insert the replacement power supply into the empty bay.
6. Tighten the captive screw on the power supply.
7. Plug the electrical cable into the power supply.
!
2750
On/Standby
switch
2918a
Captive
screw