Polaris 2007 Victory Hammer - Manual (Page 132)

127
MAINTENANCE
Headlamp Adjustment
The headlamp should shine straight ahead of the
motorcycle. The top of headlamp high beam should
be just below the center of the lamp at a distance of
25 feet (7.62 m). The low beam pattern spreads
farther right of center than the high beam (U.S. &
Canada).
1. Check and adjust the tire pressure (page 115)
2. Verify rear suspension ride height measurement
is 132mm (5--3/16 inch) (see page 93) before
adjusting headlight.
3. Straddle the motorcycle in an upright position
and sit in the operator’s seat.
4. Set the ignition switch to the ON position and
set the headlamp to High beam. Check the
headlamp for correct aim.
5. To adjust the headlamp vertically, loosen pivot nut (1)
while holding bolt. Aim headlight and hold in position
while tightening nut.
Torque: 35 ft-lbs (47.5 Nm)
6. To adjust the lamp horizontally, loosen the nut (2), aim
headlight and hold in position while tightening nut.
Torque: 28 ft-lbs (38 Nm)
7. Verify proper headlamp adjustment and re-adjust if
necessary.
25 feet (7.62 m)
Center of Headlamp
High Beam
1
2