Polaris 2009 Victory Victory Vision - Manual (Page 128)

125
OPERATION
Oper
at
ion
Stopping The Engine
Before stopping the engine, bring the motorcycle to a complete stop either in neutral or
with the clutch disengaged. Once the motorcycle is at a complete stop, if it is not already in
neutral, shift into neutral. To stop the engine, set the engine STOP/RUN switch to the
STOP position, turn the ignition switch to the OFF position, and remove the ignition key .
NOTE: A momentary clicking noise from the Idle Air Control (IAC) valve is normal when the ignition
key is turned to OFF.
WARNING
• Stopping the engine while the motorcycle is in motion and the transmission is engaged
may damage the engine and the transmission or cause the rear wheel to lose traction. In
either case, you could lose control.
• If the motorcycle is in motion and the engine stops on its own, guide the motorcycle to a
safe location off the road and away from traffic.
visionownersmanual.book Page 125 Wednesday, February 13, 2008 4:31 PM