Maintenance, Emission control information – Polaris 2012 600 IQ Shift User Manual
Page 82
 
78
MAINTENANCE
Emission Control Information
Any qualified repair shop or qualified person may maintain, replace, or 
repair the emission control devices or systems on your snowmobile.
Emission Control Label
Your snowmobile is equipped at the time of sale with an emission con-
trol information (ECI) label and a factory-installed emissions informa-
tion hangtag. These items are required by U.S. Environmental 
Protection Agency regulations. The ECI label is permanently affixed to 
either the right side of the tunnel or the engine recoil cover. The ECI 
label should not be removed, even after you purchase the snowmobile. 
You may remove the factory-installed emissions information hangtag, 
which is intended solely for your use in making a purchasing decision.
Emission Control Maintenance Requirements
Your snowmobile is certified to operate on gasoline with a minimum 
octane level of 87 (R+M)/2. If your snowmobile is equipped with a 
check engine light and it comes on, you must take your snowmobile to a 
qualified dealer for diagnostic service. Specifications and adjustments 
for engine tune-ups are located in the Service Manual, which is avail-
able to your qualified service technician. Reverse (if equipped) must not 
be engaged during engine tune-ups.
Owner's Responsibilities
Please read the Snowmobile Engine Emissions Limited Warranty, and 
read the maintenance section of your owner's manual. You are responsi-
ble for ensuring that the specified maintenance is performed. POLARIS 
recommends that you contact an authorized POLARIS dealer to perform 
any service that may be necessary.
Non-ionizing Radiation
This vehicle emits some electromagnetic energy. People with active or 
non-active implantable medical devices (such as heart monitoring or 
controlling devices) should review the limitations of their device and the 
applicable electromagnetic standards and directives that apply to this 
vehicle.