Polaris Series 11 Polaris Ranger 4x4 - Manual (Page 66)

64
MAINTENANCE AND LUBRICATION
Engine Oil
Oil Check (RANGER TM)
1. Position the vehicle on a level surface.
2. Start the engine and let it idle for
20-30 seconds.
3. Stop the engine and remove the
seat as described on page 29.
Remove the screws securing the service
panel and remove the panel (1).
4. Remove the dipstick (2) and wipe it
dry with a clean cloth.
5. Replace the dipstick and seat it completely.
6. Remove the dipstick and check to see
that the oil level is between the FULL
(3) and ADD (4) marks. Add oil
through the oil filler hole (5) as needed.
Do not overfill.
NOTE: A rising oil level between checks
in cool weather driving can indicate
moisture collecting in the oil reservoir. If
the oil level is over the full mark, change
the oil.
Oil and Filter Change (RANGER TM)
1. Position the vehicle on a level surface.
2. Run the engine two to three minutes until
warm, then stop the engine.
3. Clean the area around the drain plug (6) at
the bottom of the engine. The plug is
accessible through the access hole in the
bottom of the skid plate.
4. Place a drain pan beneath the engine and remove the drain plug.
Allow the oil to drain completely.
1
2
4
5
6
3
CAUTION
Hot oil can cause serious burns. Do not allow hot oil to come
into contact with skin.