Polaris 2013 BRUTUS Operators Handbook - Manual (Page 8)

9924342 8
LEAVING THE VEHICLE
PUTTING ON THE ATTACHMENT USING PRO-TACH
NA5901
2
1. Lower the attachment arm and put
the attachment flat on the ground.
1
NA5920
2. Move the gear selector lever to Park.
Disengage the PTO system (if
equipped). Stop the engine and
remove the key.
Attachment pins must be fully installed
and secured with the retainer pins.
Failure to fully install and secure pins
can allow the attachment to come off and
cause serious injury or death.
WARNING
Slowly drive forward until the front
edge of the attachment interface is
completely under the top lip of the
attachment.
Tilt the attachment interface backward
until the attachment is slightly off the
ground.
Move gear selector to PARK and stop
the engine.
Remove the two pins from the storage
location. Install the pin (Item 1) and
retainer pin (Item 2), both sides, to
secure the attachment to the
attachment interface.
Keep pins in their storage location
(Item 3) when no attachment is
installed.
NA5915
3
2
1
1
2
WARNING Always park vehicle on flat level
ground.