Maintenance, Periodic maintenance chart – Polaris 2015 Polaris M1400 User Manual
Page 55
53
MAINTENANCE
Periodic Maintenance Chart
Ź Perform these procedures more often for vehicles subjected to severe use.
E Emission-Related Service.
D Have an authorized GEM dealer perform these services.
Item
Maintenance Interval
(whichever comes first)
Remarks
Hours
Calendar
Miles (Km)
Cooling system (if applicable)
50 H
6 M
-
Inspect coolant strength seasonally;
pressure test system yearly
Ź Oil lines, fasteners
50 H
6 M
-
Inspect for leaks and loose fittings
Ź Wiring
100 H
12 M
-
Inspect for wear, routing, security; apply
dielectric grease to connectors
subjected to water, mud, etc.
D Front wheel bearings
100 H
12 M
-
Inspect; replace as needed
D
E
Fuel system
100 H
12 M
1000 (1600) Cycle key to pressurize fuel pump;
check for leaks at fill cap, fuel lines/rail
and fuel pump; replace lines every two
years.
D Toe adjustment
-
Inspect periodically; adjust when parts
are replaced
D Headlight aim
-
Adjust as needed
Ź Engine oil and filter change
100 H
6 M
1000 (1600) Change oil and filter; (perform a break-
in oil change at one month)
Ź Front Gearcase oil (if equipped)
100 H
6 M
-
Inspect level; change yearly
Ź Middle Gearcase oil (if equipped)
100 H
6 M
-
Inspect level; change yearly
Ź Rear gearcase oil (if equipped)
100 H
6 M
-
Inspect level; change yearly
Ź Transmission oil
100 H
12 M
1000 (1600) Change fluid
D
E
Fuel system
100 H
12 M
1000 (1600) Check for leaks at tank cap, lines,
pump, throttle body; replace lines every
2 years
Ź Radiator (if applicable)
100 H
12 M
-
Inspect; clean external surfaces
Ź Cooling Hoses
100 H
12 M
-
Inspect for leaks
Ź Engine mounts
100 H
12 M
-
Inspect
Exhaust muffler/pipe
100 H
12 M
-
Inspect
Ź
E
Spark plug
100 H
12 M
1000 (1600) Inspect; replace as needed
D Ignition timing
100 H
12 M
-
Inspect
Ź Wiring
100 H
12 M
-
Inspect for wear, routing, security; apply
dielectric grease to connectors sub-
jected to water, mud, etc.
D
Ź
Clutches
100 H
12 M
1000 (1600) Inspect; clean; replace worn parts
D Front wheel bearings
100 H
12 M
-
Inspect; replace as needed
D Brake fluid
200 H
24 M
-
Change every two years
Spark arrester
300 H
36 M
-
Clean out
Ź Coolant
-
60 M
-
Replace coolant
Valve clearance
500 H
-
5000 (8000) Inspect; adjust as needed
Idle speed
-
Adjust as needed
D Toe adjustment
-
Inspect periodically; adjust when parts
are replaced
D
Ź
Auxiliary brake (if equipped)
-
Inspect daily; adjust as needed
Headlight aim
-
Adjust as needed