Ericsson 4422 - Manual (Page 16)

Start the Phone – Log On/Off
BusinessPhone – Ericsson Dialog 4422 IP Office 16
Start the Phone – Log On/Off
All system settings for your IP phone must be set by the system
administrator before you can use the phone.
When this is done, and the phone is connected to the local network
(LAN), your phone starts the start-up procedure automatically
when connected to the mains.
Notes:
The phone does not work during a power failure. After a
power failure the phone will restart automatically. However,
when a password is requested, you must log on before the
phone can be used again.
Reset the phone
If your phone does not work properly, you can use the following
procedure to reset the phone. This procedure will also clear the
Call list. After the procedure you must log on again to use the
phone. н Й #
Press simultaneously for at least one second to reset the
phone.