HEIDENHAIN TNC 320 (340 55x-04) - Manual (Page 62)

62 Introduction
2.3 Oper
ating Modes
Program Run, Full Sequence and Program Run,
Single Block
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or to a manual or
programmed stop. You can resume program run after an interruption.
In the Program Run, Single Block mode of operation you execute each
block separately by pressing the machine START button.
Soft keys for selecting the screen layout
Soft keys for selecting the screen layout for pallet tables (Pallet
Management software option)
Window Soft key
Program
Left: program, right: program structure
Left: program, right: status
Left: program, right: graphics (Advanced
Graphic Features software option)
Graphics (Advanced Graphic Features software
option)
Window Soft key
Pallet table
Left: program blocks, right: pallet table
Left: pallet table, right: status