HEIDENHAIN TNC 406 - Manual (Page 242)

HEIDENHAIN TNC 406, TNC 416 221
1
1
.2 T
e
st r
u
n Running a program test up to a certain block
If you only want to test the program up to a particular block:
8 Choose the program you want to test.
8 Press the soft key STOP AT N.
8 Enter the block number up to which the TNC should
run a program test.
8 If the block is located in a different program, enter the
PROGRAM.
8 If the block number is located within a program section
repeat, enter the REPEATS.
8 Start the test run with START.
Operating time
The TNC displays the simulation time between the program blocks
and the status display.