HEIDENHAIN iTNC 530 (340 49x-02) - Manual (Page 558)

558 11 Programming: Q Parameters
1
1
.8 A
d
ditional F
unctions
Example: Assign the value of the active scaling factor for the
Z axis to Q25
Value from the active datum table in
the active coordinate system, 500 NP
number 1 to 9 X axis to W axis
REF value from the active datum
table, 501 NP
number 1 to 9 X axis to W axis
Read value from the preset table,
considering the machine kinematics,
502 Preset
number 1 to 9 X axis to W axis
Read value directly from the preset
table, 503 Preset
number 1 to 9 X axis to W axis
Read basic rotation from the preset
table, 504 Preset
number - Basic rotation from the ROT column
Datum table selected, 505 1 - Return code = 0: No datum table active
Return code = 1: Datum table active
Data from the active pallet table, 510 1 - Active line
2 - Palette number from PAL/PGM field
Existence of machine parameter,
1010 MP
number MP index Return value = 0: MP does not exist
Return code = 1: MP exists
Group name, ID No. Number Index Meaning
55 FN18: SYSREAD Q25 = ID210 NR4 IDX3