HEIDENHAIN iTNC 530 (340 49x-06) Pilot - Manual (Page 119)

119
Definin
g
Mac
hin
ing Oper
ation
s
U Positions or point pattern : Define the positions at which the TNC is
to machine the contour pocket (see “Defining Machining Positions” on
page 149)
„ Specify via soft key for each subcontour whether it is a
pocket or an island.
„ As a rule, always start the list of subcontours with a pocket
(if required, the deepest pocket)!
„ On the contour detail form you can define up to a
maximum of nine subcontours.