6 workpiece setup, Selecting the correct operating mode, Clamping the workpiece – HEIDENHAIN TNC 620 (73498x-02) User Manual
Page 62: Workpiece setup
Advertising
First Steps with the TNC 620
1.6
Workpiece setup
1
62
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
1.6
Workpiece setup
Selecting the correct operating mode
Workpieces are set up in the
Manual Operation or Electronic
Handwheel mode
Press the
Manual Operation operating mode key:
the TNC switches to that mode
Further information on this topic
Manual Operation mode: See "Moving the machine axes",
page 433
Clamping the workpiece
Mount the workpiece with a fixture on the machine table. If you
have a 3-D touch probe on your machine, then you do not need to
clamp the workpiece parallel to the axes.
If you do not have a 3-D touch probe available, you have to align the
workpiece so that it is fixed with its edges parallel to the machine
axes.
Advertising