HEIDENHAIN TNC 620 (81760x-02) - Manual (Page 563)

Optional block skip 16.7
16
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 2/2015 563
16.7 Optional block skip
Application
In a test run or program run, the control can skip over blocks that
begin with a slash "/":
To run or test the program without the blocks
preceded by a slash, set the soft key to
ON
To run or test the program with the blocks
preceded by a slash, set the soft key to
OFF
This function does not work for TOOL DEF blocks.
After a power interruption the TNC returns to the
most recently selected setting.
Inserting the "/" character
In the Programming mode you select the block in which the
character is to be inserted
Select the INSERT soft key
Erasing the "/" character
In the Programming mode you select the block in which the
character is to be deleted
Select the REMOVE soft key