EverFocus EDR-1610A - Manual (Page 31)

EDR910_1610_ma_en_rev1 00 - 31 -
3.4 ALARM MENU
Define the dry alarm contacts’ attributes and the alarm reactions in the ALARM menu.
For alarm contact pin assignment, please refer to appendix D.
Each contact is adjusted individually and selected from the list on the left:
(1) ALARM:
ENABLE: Contact is activated.
DISABLE: Contact is deactivated.
(2) ALARM TYPE:
N.O.: Normally open, contact reacts on being
connected to ground (GND). Define the
alarm duration within menu item
DURATION.
N.C.: Normally closed, contact reacts on being
disconnected from ground (GND). Define
the alarm duration within menu item
DURATION.
N.O.+Trans Transparent mode, similar to normally open
but: alarm is active as long as input contact
(but minimal as defined in DURATION)
N.C.+Trans Transparent mode, similar to normally closed
but: alarm is active as long as input contact
(but minimal as defined in DURATION)
(3) ACTIVE CAMERA:
Alarm camera being recorded and displayed in full screen on the main monitor (see (10)
MAIN MONITOR). Recording is carried out according to the settings defined for EVENT
within the CAMERA menu.
COPY function
Alarm settings can be copied from one contact to another. Select the contact to be copied
from the contact list on the left and press the COPY key. The message “COPIED” appears
at the top screen margin. Select the contact which shall apply the settings from the
contact list. Press the SEARCH key to assign the copied settings to the contact. The
message “PASTED” appears at the top screen margin
ALARM
ALARM
1 ALARM ENABLE
ALARM 2 ALARM TYPE N.O.
ALARM 3
ALARM 4
ACTIVE CAMERA 01
ALARM 5
DURATION 05 SEC
ALARM 6
ALARM OUTPUT NONE
ALARM 7
ALARM EMAIL NO
ALARM 8 BUZZER OFF
ALARM 9 ALARM NETWORK NO
SUMMARY
MAIN MON NO CHANGE
CALL MON NO CHANGE
Menu display for EDR-910, EDR1610 identical, but with 16 alarm inputs.