SMA FLX Series - Manual (Page 28)

• The default setting is [undefined].
Select the grid code again, to confirm.
• The setting is activated immediately.
CAUTION
Correct selection is essential to comply with local and
national standards.
Illustration 3.16 Step 6 of 8: Grid Code
NOTICE
If the initial and confirmation settings are different,
• grid code selection is cancelled, and
• the wizard recommences step 5.
If initial and confirmation settings match, but are
incorrect, contact service.
Step 7 of 8: Replication
This step is available for a master inverter with followers connected. To replicate the settings from steps 1–6 to other
inverters in the same network:
• Select inverters.
• Click [Replicate].
Initial Setup and Start
L00410568-03_2q / Rev. date: 2014-06-20 27
3 3