Enterasys Networks ROAMABOUT RBT-1602 - Manual (Page 61)

Mounting the Antenna
RoamAbout Antenna Site Preparation and Installation Guide 3-29
Mounting the RoamAbout 4.9 to 5.9 GHz Sector Panel Antennas
You can mount the RoamAbout 4.9 to 5.9 GHz sector panel antenna (RBTES‐AW‐S1590M) to a
wide or narrow mast.
The RoamAbout 4.9 to 5.9 GHz sector panel antenna kit includes the following hardware:
• Two U‐brackets
• Four mounting brackets
• Four flat washers, and hex nuts
• Two channel washers
• Two external flaps
• Eight screws and flat washers (for external flap installation)
Figure 3‐15 and Figure 3‐16 illustrate how to mount the 4.9 to 5.9 GHz sector panel antenna on a
wide or narrow mast. Table 3‐13 lists the mast mounting components.
Refer to “ Mounting the RoamAbout 2.4 GHz Directional Antenna ” on page 3‐10 for the exact
instructions for mounting this antenna to a wide or narrow mast.
If you desire to use a 60 degree horizontal beamwidth, refer to the procedure following Table 3‐14
to install optional external flaps on both sides of the antenna as shown in Figure 3‐17 .
Figure 3-15 Mounting RoamAbout 4.9 to 5.9 GHz Sector Panel Antenna — Wide Mast
Notes: Wide masts have dimensions of 1.25 to 2.5 inches [1.66 to 2.88 Outside Dimensions (OD)]
for Schedule 40 pipe.
Narrow masts have dimensions of less than 1.25 inches (1.66 OD) for Schedule 40 pipe.
2 3 4 5
6 7
1
8