Laney CUB12R - Manual (Page 11)

12
10
11
15
13
14
11
12
13
14 15 16 17
15W INPUT: Plugging into this input uses the amplifier in full power mode.
<1W INPUT: Plugging in to this input switches the output power stage down to around 1W. (Use this feature for
recording or bedroom playing).
(Always switch off and disconnect the power cord when not in
use).
SERIAL NO: Displays the model details and serial number of the unit
EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mismatched impedance will
reduce the amplifiers performance and in some cases may cause damage to your amplifier. Try your CUB12R into a Laney
extension cabinet - you will be amazed.
MAINS LEAD: The mains lead is permanently attached so that it does not get lost or forgotten when you transport
your amp. Stow it in the straps provided when not in use to avoid damage.
EFFECTS LOOP: SEND/LINE OUT: Connect the input of
your external effect to this socket. This is an insert type control,
therefore all of the signal leaves the amplifier via the `Send’ socket
to be processed. This socket can also be used as a Line Level Out.
(-10dBV Nominal)
EFFECTS LOOP: RETURN: Connect the output from your
external effects to this socket. The effects loop allows you to
connect external effects such as tremolo, chorus and delay to your
amplifier. (-10dBV Nominal)
FOOTSWITCH SOCKET: Provided for the connection of a
Laney FS1 footswitch (optional) .This allows you to remotely
switch the built in Digital Reverb On/Off.
HANDLE: Laney soft grip handle for comfortable transportation.
11
CUB
2
R
16
17
LZB1 2 3 4 LZB1 2 3 4