Laney LX120RT - Manual (Page 11)

Controls the amount of reverb applied to the signal.
Fancy playing along with a backing track? Connect your CD/MP3 player here.
Connect a Laney FS2 footswitch here to enable remote switching for the channel and reverb/FX. Note: Drive channel must be
enabled for channel switching via footswitch to function.
Effects send socket allowing you to connect to an external FX controller. You can also use it as a line out socket if you wish to
connect to another amplifier/PA etc.
Connect the output from your effects controller here.
When ‘on’ indicates that power is connected to the unit and it is ready to go.
Main power switch for the unit.
(Always switch off and
disconnect the power cord
when not in use)
Power inlet socket. Connect to your power source. Make sure the specified voltage is correct for your country!
This drawer contains the main safety fuse for the unit.
USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL - (See specs section on page 7).
Displays the model number, power requirements and serial number of the unit.
Connect an extension loudspeaker cabinet here, the internal loudspeaker is left connected. The impedance of the extension cabinet
must not be less than 8 Ohms. Connecting cabinets that have a lower impedance than 8 Ohms will result in the amplifier
overheating. Continual use in this manner may cause permanent damage.
Power Amp In Preamp Out: These jacks are primarily used to connect other power amplifiers or to connect LX120RH amplifiers together
to boost power outputs. When connecting to another power amplifier the preamplifier output jack should be used. The signal at this socket
will be affected by all the controls on the preamplifier. When connecting two LX120RH amplifiers together to boost power levels the
master amplifier preamplifier out jack should be connected to the power amplifier input socket of the slave. The master will then be in
complete control of the slave power amplifier.
11
L Z B 1 2 3 4