Lanner FW-8750 - Manual (Page 29)

FW-8750
29
SATA#2 Configuration: These items allow you to select the SATA4/5
configuration. Select [Disabled] in Configuration if you want to disable both
ATA/IDE configuration. Select [Enhanced] to use the IDE, S-ATA and PATA devices.
Primary, Third and Fourth IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE
devices. There is a separate sub-menu for each IDE device. Select a device
item then press <Enter> to display the IDE device information.
Super IO Configuration: Press <Enter> to enter the sub-menu and the following
screen appears:
Serial Port1/2 Address:
These items specify the base I/O port addresses of the onboard Serial Port 1
Selecting [Auto] allows BIOS to automatically determine the correct base I/O
port address. Settings: [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4], [2E8/IRQ3] and
[Disabled].
Parallel Port Address: Allows you to select the Parallel Port base addresses.
Configuration options: [Disabled] [378] [278] [3BC].
Parallel Port Mode: Allows you to select the Parallel Port mode.
Configuration options: [Normal] [Bi-directional] [EPP] [ECP].
Parallel Port IRQ:
Configuration options: [IRQ5] [IRQ7].
Restore on AC Power Loss by IO