Epson 900N - Manual (Page 102)

95
For most papers, set the paper thickness lever to the 0 position.
If your printout is blurry or smeared . . .
■
Make sure your paper isn’t damp or loaded face down (the printable side should
be loaded face up). If it’s damp, reload a new stack of paper.
■
Use a support sheet with special media or try loading your media one sheet at a
time.
■
Make sure your paper or media meets the specifications listed in your electronic
EPSON Stylus COLOR 900N Manual.
■
Run the Print Head Alignment utility. See page 85 for instructions.
■
Check the paper thickness lever position. If it’s in the + position, your printer is
set for thicker paper or envelopes and your image may smear. For most papers, set
the paper thickness lever to the
0 position, as shown above.
trouble.fm Page 95 Friday, February 19, 1999 4:03 PM