Operation, Maintenance and cleaning – Parkside PHP 500 C2 User Manual

Page 7

Advertising
background image

4

PHP 500 C2

GB

Operation

Before fi rst use

Preparing the glue site:

■

Do not use infl ammable solvents to clean the
glue site.

■

The ambient temperature and temperature of
the materials to be glued must be not less than
+ 5° C and not warmer than + 50° C.

■

The glue sites must be clean, dry and free of
grease.

♦

Smooth surfaces should be roughened before
gluing.

♦

Warm any materials that are prone to cool
down quickly (e.g. steel) to improve the bond
with the glue.

♦

Screw on the appropriate nozzle .

Preparing the tool for use

Working with the mains lead connected:

♦

Connect the mains lead to the glue gun con-
nection (see Fig. B).
Insert the mains plug into the mains socket.

♦

Fold forward the plastic stand .
Stand the device up.

♦

Push a glue stick into the feed channel .

♦

Let the device heat up for about 5 minutes.
The device is now ready for use.

Cordless working:

♦

Connect the mains lead to the charger con-
nection .
Insert the mains plug into the mains socket.

♦

Place the glue gun into the charger .

♦

Push a glue stick into the feed channel .

♦

Let the device heat up for about 5 minutes.
The device is now ready for use.

♦

Repeat the heating-up procedure if the feed
switch becomes stiff or the outcoming glue
becomes viscous.

Gluing:

♦

Press the feed clamp to regulate the fl ow of
glue as required for your work.

♦

Apply the glue in individual dots. Apply in zig-
zags on fl exible materials such as fabrics.

♦

Immediately after applying the glue, press the
two materials together for about 30 seconds.
The glued joint can be loaded after about 5
minutes.

♦

When you take a break from work, set the glue
gun down on the plastic stand or in the
charger .

♦

Remove any glue residue with a sharp knife
after cooling. Glued joints can be loosened
again by applying heat.

Switching off the device:

♦

Pull the mains lead out of the mains socket.

Changing the nozzle:

■

Wear protective gloves.

♦

Heat up the device for about 5 minutes.
Change the nozzle when it is hot.

■

Danger of burns!
Touch the nozzle only by the heat shield .
The nozzle tip is hot!

NOTE

Hold item upright, tip up, to prevent glue from
fl owing out.

Maintenance and Cleaning

The glue gun is maintenance-free.

WARNING!

Pull the mains lead out of

the mains socket before you clean the
tool. Always keep the device clean and
dry.

■

Do not allow any liquids to enter the tool. Use
a soft cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.

IB_60269_PHP500C2_LB4.indb 4

23.06.14 16:15

Advertising