EVGA nForce 122-YW-E173 - Manual (Page 27)

EVGA 19
Fan Connections
There are five fan connections on the motherboard. The fan speed can be detected and
viewed in the
PC Health Status
section of the CMOS Setup. The fans are automatically
turned off after the system enters S3, S4 and S5 mode.
Note that the CPU fan cable can
be either a 3-pin or a 4-pin
connector. Connect a 3-pin
connector to pins 1, 2, and 3 on
the motherboard connector.
3 2
GND
+12V
SENSE
CPU Fan Connector
4 3 2
GND SENSE
PWR CONTROL
EVGA nForce 750i SLI SPP/MCP Fan Connector
Install the fan over the nForce 750i SLI SPP
to draw heat from the MCP. The fan plugs
into a 3-pin connector.
3 2
GND
+12V
SENSE
Auxiliary Fan
Connector