Efficient Networks SpeedStream 5667 - Manual (Page 10)

SpeedStream Dual USB/Ethernet Router User’s Guide
Model 5667
10
Hardware Features
AAL and ATM Support
VCI 0-65535 address range
Connectors
ADSL interface: RJ-11
Ethernet interface: RJ-45
Console interface: 5-pin MiniDIN RS-232
USB Type B interface
Standards Compliance
DMT, ADSL
LED Indicators
After powering on the router, all LED indicator lights turn a solid green. The LED behavior will change
depending on the various connection states and data activity of the router. Refer to the table below for
details:
power adsl act eth usb
Unlit Off DSL not
connected DSL not
connected Ethernet port not
connected; check Ethernet
cable connection if using
Ethernet interface USB port not connected;
check USB cable
connection if using USB
interface
Solid On Ready for data
traffic N/A Ethernet port connected to
LAN USB port connected to
host
Blinking N/A Searching for
signal DSL traffic
flow Ethernet traffic flow USB traffic flow
All
Blinking Post failure
Hardware Installation
Before Starting
Please collect the following information from your ISP before setting up the SpeedStream Dual
USB/Ethernet Router:
•
An ISP account (may include user name and password for PPPoE or PPPoA service)
•
IP address for your ISP’s gateway and domain name servers (for non-PPP/non-DHCP services).
•
ISP authentication type or script (if not PAP/CHAP).
•
IP address and subnet mask (for fixed IP accounts only).