Curtis RCD725 - Manual (Page 11)

DISC PLAY
Insert a CD as described in the previous section and close the disc compartment. The display
will then show the total number of tracks and total playtime.
Press the PLAY/PAUSE button. Disc play will begin from the start of the first track of the disc.
A particular track can be selected using either of the CD SKIP buttons. If this is done before
pressing the PLAY/PAUSE button, disc play will start with the selected track when the PLAY/
PAUSE button is pressed.
At the end of the disc, the unit will switch to stop mode.
Notes:
If the disc is deeply scratched, or too dirty, disc play may not start. If an improperly centered
disc is played, noise can be heard in the mechanism. The use of such discs should be
avoided.
If the disc is inserted incorrectly, or the disc is damaged the display will show "No disc”
DISC ERRORS
This compact disc player has built-in error compensation circuits to correct for minor defects
in a disc. There are limits, however, to the amount of correction available.
In some cases, the CD player may skip some tracks, or parts of tracks, on a disc during disc
play. This problem may be caused by defects (such as scratches) in the disc being played,
which are too large for the error compensation circuits to handle. If you encounter this
problem, check the CD player's operation as follows, before having the unit serviced:
Play a new disc. If the CD player operates normally, the skipping problem is probably due to a
defective disc.
TO STOP A CD PART WAY THROUGH
Press the Stop button. Disc play will stop, and the display will show the total number of tracks.
To temporarily stop disc play (pause mode), press the PLAY/PAUSE button. Disc play will stop
at the current play position. The track playing time will flash .
To resume disc play, press the PLAY/PAUSE button again.
TRACK SKIP
STARTING DISC PLAY FROM THE BEGINNING OF A PARTICULAR TRACK
Press the SKIP Forward or REW TRACK buttons to select the desired track. The number of
the selected track will be shown on the CD display. Press the PLAY/PAUSE button to start
play.
TO SKIP TO THE NEXT TRACK
For example, to skip ahead to the beginning of track 5 while track 4 is playing. . Press the
SKIP FWD TRACK button once. Disc play will resume at the beginning of track 5. The CD
player will skip ahead to the next track each time the SKIP FWD TRACK button is pressed.
Repeatedly pressing the SKIP FWD TRACK button makes the CD player skip ahead through
the disc track by track. Once the beginning of the last track is reached the CD player advance
to the first track.
9