Epson DW7464 - Manual (Page 10)

6
English
Additional Information
Adjustment:
• If you add a Mobile Base to your saw it will be
necessary to adjust the height of the legs on your 52"
Rail System:
• Place the Mobile Base under your saw as described
in the mobile base instruction manual.
• Move the saw to the location you will most likely use
it and disengage base.
• Loosen the M8 cap head screw through the open
ended slot in each side rail and the square hole in the
legs (Fig. 6). Use the adjusting hardware through the
top of the legs to adjust the leg set all the way down or
until the M8 screws are at the bottom of the open
ended slots..
• Re-tighten the M8 hardware.
• For each leg (Fig. 19): Loosen the two screws that
hold the foot to the leg. Let the foot fall to the floor sur-
face. Re-tighten the screws holding the foot to the leg.
Adjust the rear fence glide
If necessary, adjust the rear glide to locate it correctly
against the rear rail by loosening the two screws which
secure it to the fence beam. The plastic retaining clip
should be deflected somewhat when the glide is posi-
tioned correctly. This adjustment should only be necessary
if the rear rail has been relocated by the addition of an
optional accessory.
Cleaning:
• The table board of your 52" Rail System is a
composite material, excessive moisture can cause
deterioration. Cleaning with a damp cloth or a mild
solvent on the top surface is acceptable, but the
edges of the board should not be wetted.