Epson DW7464 - Manual (Page 5)

English
1
Items Included
Box #1
•
(1) 52" rail system table sub-assembly
• (1) Support pan
• (1) Support bracket
• (2) Lower support rail
• (3) Rear brackets
Box #2 (Rail Carton)
•
(1) Front rail sub-assembly
• (1) Rear rail
• (2) Legs
• (2) Feet
• (1) Hardware bag
Tools Included
• 6mm hex wrench
• Torx T40 wrench
• Torx T50 wrench
Tools Needed
• 17 mm open end wrench
• (2) 16mm or 5/8" open end wrench
• 13mm or 1/2" open end wrench
• Ruler
• Soft hammer or regular hammer and block of wood
• Small flat blade screwdriver
To speed assembly, the following would be helpful:
•
16mm or 5/8" socket wrench
• 13mm or 1/2" socket wrench
• T25 Torx driver
Necessary Hardware
The included hardware bags contains all the necessary
nuts, bolts, and washers to assemble the components
included with the DW7464 52" Rail System and to attach
it to the DW746 Woodworker’s Table Saw. (When
attaching as an add-on accessory use new hardware in
place of removed hardware).
To make assembly of your saw/accessory easier, match
the nuts, bolts, and washers with the hardware chart.
Before each step, check your hardware against the chart
and identify the pieces you need. Additional pieces may be
included in the hardware bags.
M 10 JAM NUT 17 mm HEX
(6 PIECES)
BOLT
10 mm x 25 mm
(5 PIECES)
BOLT
10 mm x 35 mm
(8 PIECES)
T50 TORX
FLAT HEAD SCREW
10mm X 30mm
(6 PIECES)
CARRIAGE BOLT
8 mm x 20 mm
(11 PIECES)
CAP HEAD SCREW
8mm x 20 mm
(15 PIECES)
10MM FLAT WASHER
(22 PIECES)
10 MM LOCK WASHER
(20 PIECES)
8 MM LOCK WASHER
(25 PIECES)
M 8 NUT 13 mm HEX
(25 PIECES)
M 10 NUT 16 mm HEX
(13 PIECES)
6 MM HEX SOCKET
FLAT HEAD SCREW
10mm X 80mm
(2 PIECES)
Hardware Included with the DW7464 52" Rail System
8MM FLAT WASHER
(19 PIECES)