ETA Systems ETA-C15D - Manual (Page 10)

– 10 – ETAsys.com
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
SPECIFICATIONS
Type Power Conditioner & Suppressor
Load Rating 15A
FRONT PANEL
Outlets 2 Unswitched
Lights 1 Pull Out LED with Dimmer Switch
Activation Switch Rocker
Circuit Breaker 15A Resettable
AC Mains Voltmeter Three Digits, Digital
Indicators AC Power On, Abnormal Voltage, AC Fault, Breaker Open, Wiring Fault
REAR PANEL
AC Outlets 8 Outlets total, 6 Filtered, 1 High Power Non-Filtered, 1 Unswitched Connector
LED Light Socket XLR Socket to provide 12VDC for optional 16" Gooseneck Lamp.
LED Light Switch Two position (On / Off)
AC Mains Power Cord 9' (3m), 14-gauge
TECHNICAL DATA
Current Rating 15 amps
Operating Voltage 102VAC – 132VAC
High Voltage Surge Protection Trigger at 133VAC, 1ms typically
Low Voltage Protection Trigger 101VAC, 1ms typically
Voltmeter Accuracy ±1.5VAC
Spike Protection Modes DCS (Dual Clamping Suppression) Circuitry on Incoming AC Mains and Each Section Output
Min. Spike Clamping Voltage 460VRMS @ 3,000A
Max. Spike Clamping Voltage 6000V
Max. Spike Clamping Resp. Time 1 nanosecond
Spike Clamping Voltage @ 100A 1250Vp for 20µs
Maximum Surge Current 6,500A
Energy Rating @ 2ms 2000 Joules
Noise Attenuation EMI/RFI 10dB @ 10kHz / 40dB @ 100kHz / 100dB @ 10MHz
Temperature Range 5° – 35°c
Humidity Range 5% to 95% R.H.
MECHANICAL
Chassis Finish Black
Mounting Rack Mount, 1RU
Height 1.75" (1RU, 44.5mm)
Width 19" (215.9mm)
Depth 8.5" (548.64mm)
Weight 7.6 lbs (3.45kg)
Power Consumption 12 watts
Agency Listings MET (UL 1449 Code)
ETA-C15D
Power Conditioner