2 unpacking, 3 part names, 4 functions – Epson UB E02 User Manual
Page 18: 1 switch, 2 leds, Unpacking -2 part names -2 functions -2, Switch -2 leds -2
2-2
Installation
Rev. A
2.2 Unpacking
❏ UB-E02
❏ UB-E02 User’s Manual
2.3 Part Names
Note: This photograph shows the TM-T88III printer with the UB-E02 installed.
2.4 Functions
The switch and LEDs of the UB-E02 provide you with important information on operation and
status of the UB-E02.
2.4.1 Switch
Type: Non-locking push switch
You can do the following with the switch.
❏ Setting initialization
All the parameters of internal settings for the UB-E02 can be set to the factory default values.
See “Initializing UB-E02” on page 7 of this chapter for more details.
❏ Status sheet printing
The internal setting parameters of the UB-E02 can be printed. See “UB-E02 Status Sheet
Printing” on page 7 of this chapter for more details.
2.4.2 LEDs
The UB-E02 has two LEDs.
The green LED is on when the Ethernet link is established.
The yellow LED is on when the printer receiving data.
10BASE-T/100BASE-TX
Ethernet interface
connector
LED (green) LED (yellow)
Switch
Drawer kick-out
connector of the printer
Power supply connector
of the printer