Epson UB E02 - Manual (Page 36)

3-10 Utilities Rev. A
Note:
To confirm the current setting, print out the status sheet. Press down the switch more than 3 seconds in
the printable state; then the status sheet is printed out.
6. Click the OK button.
7. Click the OK button again to be sure.
8. Enter the password set in the print server; then click OK. If the password is not set, just click
OK without entering the password.
CAUTION:
After clicking OK, you must not turn off the printer while the new settings are being sent
to the UB-E02.
9. The update is complete when the message “Configuration is successfully done” appears.
Note:
To get the information for the UB-E02 for the other segments, refer to the EPSON TMNet WinConfig
Functions
section.