Enterasys Networks 5H1XX - Manual (Page 85)

Configuring Traffic Classes
Device Control Menu Screens 7-25
7.10 CONFIGURING TRAFFIC CLASSES
IEEE 802.1p defines up to 8 separate traffic classes. This switch supports Quality of Service (QoS)
by using two priority queues, with weighted fair queuing for each port. You can use the 802.1P
Configuration Menu screen (
Figure 7-14 ) to access the screens to configure the default priority for
each port, or to display the mapping for the traffic classes as described in the following sections.
Also, refer to
Appendix C , for information on Class of Service.
Figure 7-14 802.1P Configuration Menu Screen
7.10.1 Port Priority Configuration
The default priority for all ingress ports is zero. Therefore, any inbound frames that do not have
priority tags will be placed in the low priority output queue. Default priority is only used to
determine the output queue for the current port; no priority tag is actually added to the frame. You
can use the 802.1P Port Priority Configuration menu screen (
Figure 7-15 ) to adjust the default
priority for any port.
802.1P Port Priority Configuration
802.1P Port Traffic Class Information
<RETURN>
3583_34