Exmark Standon 4500-435 - Manual (Page 10)

Setup
Installing the StandOn Rider
to Mower
Mounting the Pull Frame
1. Locate the pull frame and two adapter plates.
Install the pull frame to the adapter plates using
four 3/8-16 x 1 1/4 inch hex capscrews and four
3/8-16 inch nyloc nuts as shown in Figure 4.
3
4
4
2 1
1
2
G009397
Figure 4
1. 3/8-16 inch nyloc nuts
2. Adapter plate
3. Pull frame
4. 3/8-16 x 1 1/4 inch hex capscrews
2. Mounting the pull frame assembly to the engine
deck:
A. For Turf Tracer and Viking Hydro Units
Only:
a. If your unit has four holes drilled in the
rear surface of the engine deck proceed to
step c; if not, continue with step b.
b. Remove the two decals on the lower rear
surface of the engine deck (see Figure 5).
Figure 5
1. Remove these two decals.
c. Center the adapter plates on the lower rear
surface of the mower engine deck and
mark the four hole locations shown in
Figure 6. Drill four 0.407 inch diameter
holes through the engine deck at the
marked locations.
Figure 6
1. Pull frame and adapter plate assembly
2. Mark and drill two holes each side.
d. Apply the two replacement decals to the
engine deck between the mounting holes
(see Figure 7).
10