Danger, Safety – Exmark Standon 4500-435 User Manual

Page 6

Advertising
background image

Safety

DANGER

Operating on wet grass or steep slopes can
cause sliding and loss of control. Loss of
control and/or loss of operator’s footing
could result in a fall with an arm or leg
getting under the mower or engine deck
which may result in serious injury, death or
drowning.

•

Mow across slopes, never up and down.

•

Do Not mow slopes when grass is wet.

•

Do Not mow near drop-offs or near water.

•

Do Not mow slopes greater than 20
degrees.

•

Reduce speed and use extreme caution
on slopes.

•

Avoid sudden turns or rapid speed
changes.

•

See inside the back cover to determine the
approximate slope angle of the area to be mowed.

•

Remove or mark obstacles such as rocks, tree
limbs, etc. from the mowing area. Tall grass can
hide obstacles.

•

Watch for ditches, holes, rocks, dips and rises that
change the operating angle, as rough terrain could
overturn the machine.

•

Avoid sudden starts when mowing uphill because
the mower may tip backwards.

•

Be aware that operating on wet grass, across steep
slopes or downhill may cause the mower to lose
traction. Loss of traction to the drive wheels may
result in sliding and a loss of braking and steering.

•

Always avoid sudden starting or stopping on a
slope. If tires lose traction, disengage the blades
and proceed slowly off the slope.

•

Follow the manufacturer’s recommendations for
wheel weights or counter weights to improve
stability.

•

Always install and remove the StandOn as
instructed. Failure to do so will cause a reduction
in stability or traction.

Maintenance and Storage

•

Disengage drives, set parking brake, stop engine
and remove key or disconnect spark plug wire.

Wait for all movement to stop before adjusting,
cleaning or repairing.

•

Use care when checking blades. Wrap the blade(s)
or wear gloves, and use caution when servicing
them. Only replace damaged blades. Never
straighten or weld them.

•

Keep all guards, shields and all safety devices in
place and in safe working condition.

•

Check all bolts frequently to maintain proper
tightness.

•

Frequently check for worn or deteriorating
components that could create a hazard.

•

All replacement parts must be the same as
or equivalent to the parts supplied as original
equipment.

6

Advertising