Emerson 5081-T - Manual (Page 10)

4
MODEL 5081-T SECTION 1.0
DESCRIPTION AND SPECIFICATIONS
1.4 TRANSMITTER DISPLAY DURING
CALIBRATION AND PROGRAMMING
(FIGURE 1-1)
1. Continuous display of conductivity or resistivity
readings.
2. Units: µS/cm, mS/cm, ppm, or %.
3. Current menu section appears here.
4. Submenus, prompts, and diagnostic readings
appear hear.
5. Commands available in each submenu or at
each prompt appear here.
6. Hold appears when the transmitter is in hold.
7. Fault appears when the transmitter detects a
sensor or instrument fault.
8.
♥
flashes during digital communication.
1.5 INFRARED REMOTE CONTROLLER
(FIGURE 1-2)
1. Pressing a menu key allows the user access to
calibrate, program, or diagnostic menus.
2. Press ENTER to store data and settings. Press
NEXT to move from one submenu to the next.
Press EXIT to leave without storing changes.
3. Use the editing arrow keys to scroll through lists
of allowed settings or to change a numerical set-
ting to the desired value.
4. Pressing HOLD puts the transmitter in hold and
sends the output current to a pre-programmed
value. Pressing RESET causes the transmitter
to abandon the present menu operation and
return to the main display.
FIGURE 1-2. INFRARED REMOTE CONTROLLER
1.
4.
3.
2.
CALIBRATE PROGRAM DIAGNOSE
/ - [ 5 E S - U 1
E X I T N E X T E N T E R
mS/cm
F
A
U
L
T
H
O
L
D
6
7
8
3
4
1
2
5
FIGURE 1-1. TRANSMITTER DISPLAY DURING
CALIBRATION AND PROGRAMMING
The program display screen allows access to calibration and
programming menus.
♥
#"c""