Electrolux EKM 70150 - Manual (Page 29)

electrolux 29
LEVELLING FEET
PENCIL LINE ON THE FLOOR
PLAN VIEW OF THE COOKER
580 mm.
100 mm.
300 mm.
295 mm.
WALL FACE
A
BACK OF COOKER
SIDE VIEW
OF THE COOKER
BASE OF COOKER
ENGAGEMENT EDGE FOR
STABILITY BRACKET
Fitting the Stability Bracket
(Not supplied)
If the cooker has to be installed with a
flexible supply pipe, it is necessary that a
stability device is fitted.
(See "Important Safety Requirements").
The stability bracket should be fitted by
the installer and these instructions should
be read in conjunction with the leaflet
packed with the stability bracket.
Place cooker in its intended position and
level cooker.
Mark off 295mm (11 1 /
2
") from the right
hand side of the cooker as shown, this is
the centre line of the bracket fixing.
Draw a line 100mm (4") from the front
edge of the levelling feet and remove
cooker from its position. Mark off 580mm
(23") back from this line on the centre line
of the bracket to locate the front edge of
the lower bracket.
Fix lower bracket (with two fixing holes)
to the floor, then measure height from
floor level to engagement edge on back
of cooker, dimension 'A' of figure.
Assemble upper bracket to lower bracket
so that underside of bracket is dimension
'A' +3mm (1/8") above floor level. Re-
position cooker and check that top
bracket engages into cooker back to a
depth of 75mm (3"), as shown in figure.
Should the stability bracket currently
installed not allow the cooker to stand
correctly, ask the installer to replace it with
the correct type.