Enviro 2100 - Manual (Page 9)

9
Specifications
W
OOD STOVE
S
PECIFICATIONS
:
Model 2100 Freestanding
Width x Depth 24” x 30” (610 mm x 762 mm)
Height with pedestal or legs 33” (838 mm)
Height of body 22” (559 mm)
Fire box size (depth x width x height) 211⁄2” x 18” x 12” (546 mm x 457 mm x 305 mm)
Capacity 3.1 feet3 (0.0878 meter3)
* Approximate heating area 2100 feet2 (195.1 meter2)
**E.P.A. output rating 11,800 to 34,000 BTU/hour (3,455 to 9,956 watt)
*Duration on low burn 9 to 11 hours
Weight without bricks 414 pound (188 Kg)
Weight of bricks 103.2 pound (46.8 Kg)
E.P.A. Emissions 2.9 grams/hour (0.102 oz/hour)
* Figures Will Vary Considerably With Fuel And Conditions.
** E.P.A. output is calculated from a load of fir averaged from start until entirely consumed. The actual
heat output with refueling is very much greater.
CERTIFICATION: these stoves have been tested and listed by Intertek (ITS) (WH) to standards CSA
B366.2/ULC-S627, ULC-S628-M93, UL 1482-1994.
C
LEARANCES
T
O
C
OMBUSTIBLES
- F
REESTANDING
:
MAINTAIN THESE MINIMUM CLEARANCES TO UNSHIELDED COMBUSTIBLES*
With Single Wall Pipe
A From side wall to side of unit 22” (559 mm)
B From rear wall to back of unit 12” (305 mm)
C From adjacent wall to corner of unit 8” (203 mm)
D From side wall to collar 31” (787 mm)
E From rear wall to collar 161⁄2” (419 mm)
F From adjacent wall to collar 19” (483 mm)
G † From front of unit to edge of hearth pad 18” (457 mm)
H † From side/back of unit to edge of hearth pad 8” (203 mm)
CAUTION: An uninsulated smoke pipe must not pass through an attic, roof space,
closet or similar concealed space, or through a floor, ceiling, wall, or
partition, or any combustible construction.
† FLOOR PROTECTION: If a stove is installed on a combustible floor, it must
have a pedestal attached and be on a NON COMBUSTIBLE hearth pad.
�
� �
�
�����
������
�
�
�
�
�����
���� ����
��
�
�
�
��
�
�
�
�
��
��
�
�������� ����
�
�
��
��
�
�
�
��
�