Casio PX-760 - Manual (Page 16)

EN-14
Playing with Different Tones
1.
Press the METRONOME button.
• This starts the metronome.
• The lamp above the START/STOP
a button flash
in time with the metronome beat.
2.
While holding down the FUNCTION button,
press the METRONOME BEAT keyboard
key.
Keep the FUNCTION button depressed as you
advance to step 3.
3.
With the FUNCTION button still depressed
from the previous step, press one of the
BEAT keyboard keys (0 to 9) to specify a beat
value.
• You can specify a beat value in the range of 0 to 9
(beats per measure). A chime will sound on the first
beat of each measure, and clicks will sound for the
remaining beats. Specifying 0 plays a straight click,
without any chime. This setting lets you practice with
a steady beat.
4.
Release the FUNCTION button and then hold
it down again as you press the
METRONOME TEMPO keyboard key.
Keep the FUNCTION button depressed as you
advance to step 5.
5.
While holding down the FUNCTION button,
use the TEMPO keys to specify a tempo
value in the range of 20 to 255 beats per
minute.
• Each press of the + or – key raises or lowers the
tempo value by 1.
• You can use the value input keys (0 to 9) to enter a
specific tempo value.
6.
Press the METRONOME button or START/
STOP a button to turn off the metronome.
NOTE
• If you used the value input keys (0 to 9) to input beat
and/or tempo values and the values are within the
allowable setting ranges, the Digital Piano will emit
a high pitch beep when you release the FUNCTION
button. If a value is outside the allowable range, a
low-pitch sound will be emitted.
• You could also use the procedure below in place of
steps 4 and 5 of the above procedure to specify a
tempo value.
– While holding down the METRONOME button,
use the TEMPO keyboard keys to specify a tempo
value in the range of 20 to 255 (beats per minute).
• In step 5 of the above procedure, pressing the + and
– keys at the same time will set the tempo of the
Concert Play lesson tune or Music Library tune that
was last selected on the Digital Piano. Pressing + and
– while recording will return the tempo value to 120.
Using the Metronome
PX760-ES-1A.indd 16 2014/06/24 10:35:13