Eureka 160 - Manual (Page 7)

HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance Keep the cleaner
operating at top efficiency Empty the dust cup and clean the filter after each use.
Empty Dust Cup
Note: Turn off the power switch and unplug the electrical cord to service.
1. Slide dust cup latch up.
2. Pull dust cup from handle section
and lift from the nozzle.
3. Grasp curve edge of motor filter
and pull out to remove. Clean motor
filter (refer to motor filter section).
4. Shake contents of dust cup into
waste container.
5. Replace motor filter. Put flat side
into dust cup. Press curve edge
into place until the rim of motor
filter rests on ribs inside dust cup.
6. Hold dust cup sides with thumbs
near the latch.
7. Position dust cup over nozzle.
8. Wrap fingers to the back of the
handle section. Gently squeeze the
sections together until the dust cup
latch locks the cup in place.
7
Latch
Motor Filter