Earlex 3000 - Manual (Page 16)

HELPFUL HINTS
1. Evenly control the speed of movement of the spray
gun. A fast speed will give a thin coat and a slow
speed will give a heavy coat.
2. Only apply one coat at a time. If a further coat is
required follow the paint manufacturer’s
instructions for drying times.
3. If spraying small areas or objects keep the output
setting low as this will avoid excessive use of paints
and will minimise overspray.
4. When spraying large areas or objects, it is best to
use a criss-cross pattern, either from left to right
then up or down or vice-versa. This will ensure
maximum coverage (Fig. 5).
5. Avoid stopping and starting when spraying as this
can lead to too much or not enough material on a
surface.
6. To ensure edges are covered, commence spraying
just to the side of area being sprayed
7. CLEAN SPRAYER AFTER EVERY USE (SEE
CLEANING INSTRUCTIONS)
16