Ella Moss Automobile Parts - Manual (Page 5)

M:\Product Information\366-348\Instructions\366-348 MGB Fuel Injection Installation Instructions_Grant_2.doc
366-348_Instructions_Fig 6
6.1
366-348_Instructions_Fig 6B
6.2
6.3
18. Locate the hose (6.1, 6.2) that runs from the
carb to the crankcase vent pipe (6.3) on the
front of the engine.
19. Loosen the hose clamp at the carb and
disconnect the hose.
20. Loosen the hose clamp at the crankcase
vent pipe (6.3) and remove the hose. This
hose will be replaced by a new hose
supplied in the kit.
366-348 Inst Fig 7
7.2
7.1
366-348 Inst Fig 8
8.2
8.1
21. Locate the EGR valve actuator (7.1). Check
the base of the EGR valve for any signs of a
leak. A leak here will affect how the car runs
and will make tuning the car difficult. If there
is any doubt, remove the valve and inspect
the gasket. If there are signs of a leak, you
must replace the 293-420 gasket. This gasket
is not supplied in this kit.
22. Disconnect the small hose (7.2) running from
the carb to the actuator at the actuator.
23. Find the 5/32” vacuum cap (8.1) provided in
the kit and cap the hose nipple on the
actuator. Push the vacuum cap down over
the nipple far enough to go over the flared
section (8.2) of the nipple.
Page 5 of 52