Powerplus POW6471 CULTIVATOR 140CC EN - Manual (Page 7)

POW6471
EN
Copyright © 2012 VARO P a g e | 7 www.varo.com
7.2 Assembly
7.2.1 Install the tines
Place and align the tine assembly towards to the shaft (fig. 1),
then fix it by a columniform pin and insert a split pin on the columniform pin to prevent it
moving out (fig. 2).
7.2.2 Install the wheel
Fix the wheel support assembly on the base using a bolt and a nut (fig. 3),
then tighten it using a spring, and insert a B-shape pin on the shaft to prevent the spring
moving out (fig. 4).
7.2.3 Install the handles
Place and align the handlebar arm on the base, and fix it with 4 bolts. (fig. 5)
Assemble the handlebar to the handlebar arm, fix it with 2 bolts on each side. (fig. 6)
Install the plastic cover on the handlebar. (fig. 7). Fix it with 4 screws on the back side.
Connect the clutch cable to the handle. (fig. 8) Note: if it has been installed already, you need
not perform this step.
7.2.4 Install the resistance pole
Fix the resistance pole on the base with a columniform pin, then insert a B-shape pin on the
columniform pin to prevent it moving out. (fig. 9)
8 OPERATING INSTRUCTIONS
8.1 Pre-Start Inspection
 Make sure all safety guards are in place and all nuts and bolts are secure.
 Check oil level in engine crankcase.
Important! Engine is shipped from the factory without oil. You must add
engine oil before starting engine.
 Inspect air filter for cleanliness.
 Check the fuel supply. Do not fill gas tank completely full, allow space for fuel to expand.
 Be sure spark plug wire is attached and spark plug is tightened securely.
 Check depth regulator lever position.
 Examine underneath and around engine for signs of oil or fuel leaks.
 Inspect fuel hoses for tightness and fuel seepage.
 Look for signs of engine damage.
 Remove excessive debris from muffler area and recoil starter
8.2 Start the Engine
Move the accelerator lever to “ ” position. (Fig. 10)
Grasp starter handle and pull out slowly, until it pulls slightly harder. (Fig. 11 )
Pull rope with a rapid full arm stroke until engine runs.
After engine starts running, move accelerator lever to the appropriate position. (Fig. 12)
8.3 Stop the Engine
Move accelerator lever to “OFF” position. (Fig. 13)
8.4 Normal operation
The clutch engages and disengages the power from the engine to the transmission. (Fig. 14)