Powerplus POWLI011 HALOG EN FLOODLIGHT 150W +S ENSOR EN - Manual (Page 4)

POWLI011 EN
Copyright © 2014 VARO P a g e | 4 www.varo.com
10 POSSIBLE PROBLEMS
 Ventilators, such as the discharge from a vapour cap or dryer (hot air movement) can
cause the lamp to switch on when it is not required to do so.
 Passing cars (warm engines) can also cause your lamp to switch on.
 Nearby trees and bushes, sudden changes in temperature and gusts of wind can
also cause the lamp to switch on.
 If the lamp has been placed under a roof or under trees, then the lamp can also burn
during daylight hours.
 If your lamp does not work then the bulb or fuse could be defective or there may have
been a failure in the electrical circuit.
 If the temperature difference between the object to be detected and surrounding area
is too small (in the summer for example), then your lamp will react later. The range of
detection is then 10 meters instead of 12 meters for example.
 If the electromagnetic interferences are strong enough (4KV electrostatic discharge,
3V/m electromagnetic HF-field and 1 KV electrical fast transient burst), then the lamp
may turn on unintentionally.

The light projection position must be vertical or upwards. Downwards mounted is
forbidden. Otherwise the overheating of internal wire will occur. Details see following
picture.
11 SPECIFICATION
Type POWLI011
Power 150W
Voltage/frequency 220-240V~50Hz
Bulb type Tungsten halogen tube
Bulb holder R7s
Bulb life-span 1.000 hours
Floodlight facade material tempered glass
Waterproof protection grade IP44
12 ENVIRONMENT
Should your appliance need replacement after extended use, do not
discard it with the household rubbish but dispose of it in an
environmentally safe way.
Waste produced by electrical machine items should not be handled like
normal household rubbish. Please recycle where recycle facilities exist.
Check with your Local Authority or retailer for recycling advice.