Powerplus POW306502 DRILL/SCREWDRIVER 14.4V 2BATT EN - Manual (Page 7)

POW3065.. EN
Copyright © 2012 VARO P a g e | 7 www.varo.com
§ Never completely discharge the rechargeable battery.
§ You will have long service life if the rechargeable battery is regularly loaded and then
recharged.
8.2 Operating instructions :
8.2.1 Setting the torque :
§ Your cordless drill is fitted with a 24-level torque setting (4) with a slip coupling. This
enables you to select the perfect setting for the job in hand.
§ Start work with a low torque setting.
§ When you insert the first screw you will find out how much torque is required.
§ If the torque provided by the current setting is inadequate, set it to the next level.
§ If the screw can be inserted as intended down to the surface of the workpiece, the
drill/screwdriver is set to the correct torque.
8.2.2 Keyless chuck :
§ To insert drill bits : set the drill to turn clockwise, insert the bit and hold the front ring on the
chuck. Start the drill at a slow speed.
§ To remove drill bits : set the drill to turn anti-clockwise and hold front ring on the chuck.
Start the drill at a low speed.
8.2.3 Electronic speed control :
§ By pressing the ON/OFF switch (1) you can control the speed of the drill from 0 to
maximum speed.
8.2.4 Direction of rotation :
§ Set speed setting to .
§ Set direction of rotation slider to clockwise rotation.
§ Position bit and slowly increase speed and drilling pressure.
8.2.5 Screwing :
§ Torque setting to 1-24.
§ Set the direction of rotating slider to clockwise.
§ For removing screws set it to anti-clockwise.
§ Use the appropriate flathead or crosshead bit.
8.2.6 To switch over from 1st gear to 2nd gear :
You can use a higher or lower speed depending on the gear that you have selected.
§ 1st gear : low speed (screw driving).
§ 2nd gear : high speed (drilling).
§ To avoid damaging the gear, always wait until the machine has reached a standstill before
you move the gear switch.